Differences

This shows you the differences between two versions of the page.

--- en:c1_hardware [2016/10/13 15:39]
odroid [Enable the OTG device function on ODROID-C1+]
+++ en:c1_hardware [2017/07/04 11:02] (current)
john1117 [Expansion Connectors]
@@ Line 80: / Line 80: @@
 |37|ADC.AIN1|10bit ADC#1 (0~1.8Volt)| |38|1.8V Power|For ADC reference voltage. Output!| |
 |39|Ground| | |40|ADC.AIN0|10bit ADC#0 (0~1.8Volt)| |
+{{:en:c1:c1_j2_2.png?600|}}
 **J7 - 1x7 pins**
@@ Line 86: / Line 88: @@
 ^ Pin Number ^ Expansion Net Name ^ Description ^ Driving Capability ^
 |1|Ground|  | |
-|2|GPIOAO.BIT6|I2S Data Input  | 2mA |
+|2|GPIOAO.BIT6|SPDIF Output  | 2mA |
 |3|P5V0| 5.0V Power| |
 |4|GPIOAO.BIT8| I2S MCLK | 2mA |
@@ Line 92: / Line 94: @@
 |6|GPIOAO.BIT9| I2S SCLK | 2mA |
 |7|GPIOAO.BIT11| I2S Data Output | 2mA |
+{{:en:c1:c1_j7_2.png?600|}}
 ====== UART Console Connector ======
 <code>
@@ Line 106: / Line 110: @@
 ====== Enable the OTG device function on ODROID-C1+ ======
 C1+ PCB Rev 0.4 2015/09/30 has a new **jumper J8**.
+<WRAP round important 80%>
+** Remove the Jumper on J8 if you don't use the USB OTG port as a power input ** \\
+It will reduce the power consumption and heat significantly.
+</WRAP>
 {{:en:c1:c1_20150930.png?600|}}
@@ Line 122: / Line 131: @@
 //
 //
-<WRAP center round important 80%>
+<WRAP round important 80%>
 ** Caution : Over-Voltage Protection feature **