This is an old revision of the document!
If you want to boot the ODROID-C2 via otg port, please using 5V/2A adapter.
OTG booting is unstable in some environment.
Most of features of this page are in here
OTG booting is unstable in some environment.
Most of features of this page are in here
This page describes the use of the OTG port.
OTG Booting
The ODROID-C2 can be powered by not only DC jack, but also OTG port.
Before using a OTG port, you should check your ODROID-C2 header pin J1.
As you can see, when you want to power the ODROID-C2 via the OTG port, you have to plug the J1 jumper.
If the J1 jumper is not connected, the OTG port can't be used for the power input.
OTG port & DC jack
But when you connect ODROID-C2 to the DC jack and the OTG port together, and ODROID-C2 be powered via DC jack, you must remove the J1 jumper!
Otherwise, your C2 board can be damaged.
So you should disconnect J1 pins like the above picture.
