This is an old revision of the document!
If you want to boot the ODROID-C2 via otg port, please using 5V/2A adapter.
OTG booting is unstable in some environment.
Most of features of this pages are in here
OTG booting is unstable in some environment.
Most of features of this pages are in here
OTG Booting
The ODROID-C2 can be powered by not only DC jack, but also OTG port.
Before using a OTG port, you should check your ODROID-C2 header pin J1.
As you can see, when you want to power the ODROID-C2 via the OTG port, you have to connect J1 pin via the jumper.
If the J1 jumper is not connected, OTG port can't be used the power supply.
OTG port & DC jack
But when you connect ODROID-C2 to the DC jack and OTG port, and ODROID-C2 be powered via DC jack, you must disconnect J1 pin via the jumper!
Sometimes, you can fry the board!
So you should disconnect J1 pin via the jumper, like a picture.
