Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
en:xu3_hardware_uart [2015/03/28 14:30] odroid created |
en:xu3_hardware_uart [2016/01/14 09:47] (current) odroid |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | |||
+ | There is a UART port on the 30pin header. | ||
+ | |||
+ | **CON10 - 2x15 pins** | ||
+ | ^ Pin Number ^ Net Name ^ GPIO & Export No ^ Default Pin State ^ | ||
+ | | 6 | UART_0.RXD | GPA0.0 (#171) | I(PUDN) | | ||
+ | | 8 | UART_0.TXD | GPA0.1 (#172) | I(PUDN) | | ||
+ | |||
+ | Access device node \\ | ||
+ | /dev/ttySAC0 | ||
+ | |||
+ | **I/O voltage range is 0~1.8Volt. Otherwise your ODROID will be damaged permanently.** | ||
+ | |||
+ | Refer this link to learn how to use the UART interface. | ||
+ | [[en:u3_ioport_uart|UART interface using the IO-Port #1]] | ||