Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
en:picwriting [2016/02/25 09:58] john1117 [IPE Settings] |
en:picwriting [2016/02/25 10:05] (current) john1117 [MPLAB IDE Download & Install] |
||
---|---|---|---|
Line 5: | Line 5: | ||
[[http://www.microchip.com/mplab/mplab-x-ide]] | [[http://www.microchip.com/mplab/mplab-x-ide]] | ||
- | Run MPLABX installer | + | **Run MPLABX installer** |
- | {{:en:ioboard:mplabxinstaller.png?200|}} | + | {{:en:ioboard:mplabxinstaller.png?400|}} |
- | Sellect | + | **Sellect MPLAB IPE.** |
- | {{:en:ioboard:mplabipeinstall.png?200|}} | + | {{:en:ioboard:mplabipeinstall.png?400|}} |
- | Run MPLAB IPE | + | **Run MPLAB IPE.** |
- | {{:en:ioboard:mplabipe.png?200|}} | + | {{:en:ioboard:mplabipe.png?400|}} |
==== IPE Settings ==== | ==== IPE Settings ==== | ||
- | Select device and tool | + | **Select device and tool.** |
- | {{:en:ioboard:ipeconfig.png?200|}} | + | {{:en:ioboard:ipeconfig.png?400|}} |
Family : Advanced 8-bit MCUs (PIC18) | Family : Advanced 8-bit MCUs (PIC18) | ||
Line 27: | Line 27: | ||
Tool : PICkit3 | Tool : PICkit3 | ||
- | Connect power to your USB-IOBOARD using microUSB cable.\\ | + | **Connect power to your USB-IOBOARD using microUSB cable.\\ |
- | Then, connect PICkit3. | + | Then, connect PICkit3.** |
- | {{:en:ioboard:ioboardwithpickit.jpg?200|}} | + | {{:en:ioboard:ioboardwithpickit.jpg?400|}} |
- | **Apply && Connect** | + | **Apply && Connect.** |
- | {{:en:ioboard:ipeconnect.png?200|}} | + | {{:en:ioboard:ipeconnect.png?400|}} |
- | Bootloader Download | + | **Bootloader Download.** |
- | Select the bootloader hex file. | + | {{ :en:fw.zip}} |
- | Run Program | + | **Select the bootloader hex file.** |
+ | {{:en:ioboard:ipehexfile.png?400|}} | ||
+ | **Run Program.** | ||
+ | |||
+ | {{:en:ioboard:ipeprogram.png?400|}} |