Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
en:c2_lirc_gpio_blaster [2016/11/29 16:29] joy.cho [Building and Testing an IR LED Circuit] |
en:c2_lirc_gpio_blaster [2017/05/23 12:45] joy.cho [Install LIRC Package] |
||
---|---|---|---|
Line 2: | Line 2: | ||
<WRAP center round important> | <WRAP center round important> | ||
This functionality is available on Ubuntu. | This functionality is available on Ubuntu. | ||
- | * ODROID-C2 : Version should be 3.14.79-94 (Nov 21 2016) or higher. | + | * ODROID-C2 : Version should be 3.14.79-94 (Nov 21, 2016) or higher. |
- | * ODROID-C1 : Version should be 3.10.104-175 (Nov 21 2016) or higher. | + | * ODROID-C1 : Version should be 3.10.104-175 (Nov 21, 2016) or higher. |
+ | * ODROID-XU3/4 : Version should be 3.10.104-126 (Nov 29, 2016) or higher. | ||
</WRAP> | </WRAP> | ||
Line 49: | Line 50: | ||
| GND | Pin #28 - Ground | | | GND | Pin #28 - Ground | | ||
| GPIO | Pin #26 - GPIO #24 | | | GPIO | Pin #26 - GPIO #24 | | ||
+ | |||
+ | **In case of XU4, voltage level of VDD_IO and GPIO output is 1.8V.\\ | ||
+ | Supposing R2 is 10 Ohm, the actual forward current is around 40mA and voltage difference between P1 and P2 is around 400mV. \\ ** | ||
http://odroid.com/dokuwiki/doku.php?id=en:xu4_hardware#expansion_connectors | http://odroid.com/dokuwiki/doku.php?id=en:xu4_hardware#expansion_connectors | ||
- | ===== Installing and Configuring the LIRC and the driver module ===== | + | ===== Install LIRC Package ===== |
+ | <code> | ||
+ | $ sudo apt-get install lirc | ||
+ | </code> | ||
+ | |||
+ | Install LIRC package. While installing lirc, you will be asked the device type of IR receiver and transmitter.\\ | ||
+ | Since we will set up later by manual, you can select **None**.\\ | ||
+ | |||
+ | |||
+ | And for further information, please refer to the following wiki page.\\ | ||
+ | http://odroid.com/dokuwiki/doku.php?id=en:c2_lirc | ||
+ | |||
+ | ===== Configuring the LIRC and the driver module ===== | ||
=== LIRC Configuration === | === LIRC Configuration === | ||