Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
en:c2_lirc [2016/08/17 09:25] odroid [GPIO based IR] |
en:c2_lirc [2017/07/14 09:48] (current) joy.cho [Registering own remote controller] |
||
---|---|---|---|
Line 83: | Line 83: | ||
===== Registering own remote controller ===== | ===== Registering own remote controller ===== | ||
+ | |||
+ | <WRAP center round important> | ||
+ | Before runing irrecord, please make sure service lircd should release the node, /dev/lirc0. | ||
+ | <code> | ||
+ | root@odroid64:~# sudo kill `pidof lircd` | ||
+ | </code> | ||
+ | https://forum.odroid.com/viewtopic.php?f=141&t=27593 | ||
+ | </WRAP> | ||
+ | |||
**Lirc** package provide a tool, **irrecord**, to help registering the buttons of own remote controller. Once the tool is started, for example, you will be asked to press the buttons and it will analyse the signals of your remote controller like protocol type or headers. After this analysis you can start register the buttons one by one. | **Lirc** package provide a tool, **irrecord**, to help registering the buttons of own remote controller. Once the tool is started, for example, you will be asked to press the buttons and it will analyse the signals of your remote controller like protocol type or headers. After this analysis you can start register the buttons one by one. | ||
<code> | <code> | ||
Line 181: | Line 190: | ||
^ IR Receiver ^ C2 Expansion Net ^ Description ^ | ^ IR Receiver ^ C2 Expansion Net ^ Description ^ | ||
- | |IR|Pin#8 GPIOX.BIT21|IR output | | + | |IR|Pin#7 GPIOX.BIT21|IR output | |
|GND|Pin#14 GND|Ground | | |GND|Pin#14 GND|Ground | | ||
|3V3|Pin#17 3.3V Power| 3.3V Power| | |3V3|Pin#17 3.3V Power| 3.3V Power| |