UART interface using the C1 Tinkering Kit

There are two UART ports on the C2.

The first one is mapped to /dev/ttyS1 which is connected to 40-pin header Pin #8 & #10.

The second one is mapped to /dev/ttyS0 which is connected to Serial Console Port CON5.

You need to prepare below items.

• ODROID-C2
• USB-UART Module Kit
• jumper wire x4
• serial comunication utility on your Host PC

You will connect jumper wire as below picture.
Connect the USB-PORT of USB-UART Module to your HOST PC
The RXD and TXD must be twisted each other.

1. HOST PC setup.
You will open USB Module Device on your HOST PC.
Ubuntu
Install serial comunication utility.

sudo apt-get install minicom

After check your usb serial node, Open serial port.

ls /dev/ttyUSB*
sudo minicom -b 115200 -D /dev/ttyUSB0

2. Target board(ODROID-C2) setup.
Set a serial node on your ODROID-C2

stty -F /dev/ttyS1 115200

3. ODROID-C2 → HOST PC test.
ODROID-C2

echo 1 > /dev/ttyS1

4. HOST PC → ODROID-C2 test.
ODROID-C2

cat /dev/ttyS1

HOST PC
Send characters via minicom.

_____UART____
|           |
|Pin 4 - GND|
|Pin 3 - RXD|
|Pin 2 - TXD|
|Pin 1 - VCC|
|_          |
  |_________|

3.3V LVTTL

How to enable the RTS/CTS