1.		2.
	Screw the left and right pieces to the hard disks. (A + B + P)		Attach the Cloudshell-2 board to the hard disks.(K)
3.		4.
	Screw CloudShell-2 board to left/right pieces. (O)		Assemble the FAN and back piece and place the FAN at the back side. Use only 3 screws in this step. (E + G + N)
5.		6.
	Insert the FAN cable to the CloudShell-2 board.		If you want to use quiet fan mode, connect the current limit PCB between the FAN cable connector and the Cloudshell-2 board.
7.		8.
	Assemble the ODROID-XU4 and XU4 holder pieces. (J + M + Q + R)		Connect micro B side of USB 3.0 cable to the Cloudshell-2 board. (H + K)
9.		10.
	Connect GPIO ribbon cable between ODROID-XU4 and CloudShell-2 board. (F + K)		Connect type A side of USB 3.0 cable to ODROID-XU4.
11.		12.
	Place the front piece at the front side. (C)		Cover the top piece on the top. (D)
13.		14.
	Put the locker piece and screw it. (I + N)