16x2 LCD + IO Shield on ODROID-C

Build the wiringPi on ubuntu

Note

Before starting this guide, you should check whether the 1-wire module is loaded or not. Because 1-wire and LCD_RS share the GPIOX_21 pin.

odroid@odroid64:~$ lsmod
Module                  Size  Used by
w1_gpio                 3785  0
wire                   25687  1 w1_gpio
(...)

To use the LCD-IO Shield with wiringPi you build the wiringPi library first.

1. Get the wiringPi library compatible ODROID Series.

git clone https://github.com/hardkernel/wiringPi

2. Build the library

cd wiringPi
./build

1. Get a source code.
example-lcd.c

wget http://dn.odroid.com/source_peripherals/16x2lcdio/example-lcd.c

2. Compile & Run

gcc -o example-lcd example-lcd.c -lwiringPi -lwiringPiDev -lpthread
sudo ./example-lcd

1. Get a source code.
lcd_time.c

wget http://dn.odroid.com/source_peripherals/16x2lcdio/lcd_time.c

2. Compile & Run

gcc -o lcd_time lcd_time.c -lwiringPi -lwiringPiDev -lpthread
sudo ./lcd_time

1. Get a source code.
wiring_isr.c

wget http://dn.odroid.com/source_peripherals/16x2lcdio/wiring_isr.c

2. Compile & Run

gcc -o wiring_isr wiring_isr.c -lwiringPi -lwiringPiDev -lpthread
sudo ./wiring_isr

3. Push the SW1 on 16x2lcd board