Differences

This shows you the differences between two versions of the page.

--- odroid-c2:gettingstart:c2_gettingstart_otg_booting [2017/05/29 12:03]
luke.go
+++ odroid-c2:gettingstart:c2_gettingstart_otg_booting [2017/05/31 15:44] (current)
luke.go
@@ Line 1: / Line 1: @@
-<note warning>
+<WRAP round important 60%>
 If you want to boot the ODROID-C2 via otg port, please using 5V/2A adapter.\\
 OTG booting is unstable in some environment.\\
-Most of features of this pages are in [[en:c2_hardware#enable_the_otg_device_function_on_odroid-c2|here]]
+Most features are described in [[en:c2_hardware#enable_the_otg_device_function_on_odroid-c2|here]]
-</note>
+</WRAP>
+This page describes the use of the OTG port.\\
 ==== OTG Booting ====
@@ Line 9: / Line 11: @@
 Before using a OTG port, you should check your ODROID-C2 header pin J1.
-{{:en:odroid-c2:gettingstart:connect_j1_otg.png?direct|}}
+{{odroid-c2:gettingstart:connect_j1_otg.png?direct|}}
-As you can see, when you want to power the ODROID-C2 via the OTG port, you have to connect J1 pin via the jumper.\\
+As you can see, when you want to power the ODROID-C2 via the OTG port, you have to plug the J1 jumper.\\
-If the J1 jumper is not connected, OTG port can't be used the power supply.\\
+If the J1 jumper is not connected, the OTG port can't be used for the power input.\\
 ==== OTG port & DC jack ====
-{{:en:odroid-c2:gettingstart:wrong_j1.png?direct|}}
+{{odroid-c2:gettingstart:wrong_j1.png?direct|}}
-But when you connect ODROID-C2 to the DC jack and OTG port, and ODROID-C2 be powered via DC jack, you must disconnect J1 pin via the jumper!\\
+But when you connect ODROID-C2 to the DC jack and the OTG port together, and ODROID-C2 be powered via DC jack, you must remove the J1 jumper!\\
-Sometimes, you can fry the board!
+Otherwise, your C2 board can be damaged.
-{{:en:odroid-c2:gettingstart:j1_disconnected.png?direct|}}
+{{odroid-c2:gettingstart:j1_disconnected.png?direct|}}
-So you should disconnect J1 pin via the jumper, like a picture.
+So you should disconnect J1 pins like the above picture.