Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:xu4_cloudshell2:software_settings [2017/05/19 18:29] brian.kim |
en:xu4_cloudshell2:software_settings [2017/06/01 11:13] (current) brian.kim |
||
|---|---|---|---|
| Line 77: | Line 77: | ||
| LABEL=boot /media/boot vfat defaults 0 1 | LABEL=boot /media/boot vfat defaults 0 1 | ||
| /dev/sda /media/hdd ext4 defaults 0 1 | /dev/sda /media/hdd ext4 defaults 0 1 | ||
| + | </code> | ||
| + | <code> | ||
| + | # mount /media/hdd | ||
| </code> | </code> | ||
| * PM mode | * PM mode | ||
| Line 89: | Line 92: | ||
| /dev/sda /media/hdd1 ext4 defaults 0 1 | /dev/sda /media/hdd1 ext4 defaults 0 1 | ||
| /dev/sdb /media/hdd2 ext4 defaults 0 1 | /dev/sdb /media/hdd2 ext4 defaults 0 1 | ||
| + | </code> | ||
| + | <code> | ||
| + | # mount /media/hdd1 | ||
| + | # mount /media/hdd2 | ||
| </code> | </code> | ||
| Line 156: | Line 163: | ||
| force user = cloudshell | force user = cloudshell | ||
| </code> | </code> | ||
| - | |||
| - | <WRAP center round tip 100%> | ||
| - | **12 and 13 step is for samba performance optimization** | ||
| - | </WRAP> | ||
| **12. Add the configurations below to the [global] section of the ///etc/samba/smb.conf// file.** [On ODROID-XU4] | **12. Add the configurations below to the [global] section of the ///etc/samba/smb.conf// file.** [On ODROID-XU4] | ||
| Line 170: | Line 173: | ||
| </code> | </code> | ||
| - | **13. Add the system configurations to ///etc/rc.local// file.** [On ODROID-XU4] | ||
| - | <code> | ||
| - | ifconfig eth0 mtu 6975 | ||
| - | echo 5 > /proc/irq/$(cat /proc/interrupts | grep 104 | awk -F : '{print $1}')/smp_affinity_list | ||
| - | echo 6 > /proc/irq/$(cat /proc/interrupts | grep 105 | awk -F : '{print $1}')/smp_affinity_list | ||
| - | echo f > /sys/class/net/eth0/queues/rx-0/rps_cpus | ||
| - | </code> | ||
| - | **14. Install CloudShell-2 specific packages: enable LCD, FAN and IR.** | + | **13. Install CloudShell-2 specific packages: enable LCD, FAN and IR.** |
| -> Refer to [[en:xu4_cloudshell2|Cloudshell-2 wiki page]] | -> Refer to [[en:xu4_cloudshell2|Cloudshell-2 wiki page]] | ||
| - | **15. Reboot and done!** | + | **14. Reboot and done!** |
| <code> | <code> | ||
| # reboot | # reboot | ||
| </code> | </code> | ||
