Differences

This shows you the differences between two versions of the page.

--- en:xu4_cloudshell2:easy_install [2017/04/20 16:48]
john1117
+++ en:xu4_cloudshell2:easy_install [2017/04/20 17:16] (current)
john1117
@@ Line 1: / Line 1: @@
-Enabling/Configure the LCD
+=== 1. Set the RAID mode ===
+{{:en:raid_select.png?600|}}
+There are four data storage modes on the CloudShell2:  **//RAID 0, RAID 1, SPAN//** and **//PM//**.  This means that the hard disks will be detected separately in PM mode.\\
+To select the RAID mode, set the RAID Mode DIP Switch to the setting that you want, then apply power while pressing the RAID Setup Key button until booting is complete.
+=== 2. Configure LCD and Fan ===
+**Enter the following commands to enable the LCD and fan.**
+Enabling/Configure the LCD
   wget https://github.com/john1117/odroid-cloudshell/raw/master/odroid-cloudshell_20170420-4_armhf.deb
   sudo dpkg -i odroid-cloudshell_20170420-4_armhf.deb
-fan configuration
+Fan configuration
   wget https://github.com/john1117/cloudshell2-fan/raw/master/cloudshell2-fan_20170420-1_armhf.deb
   sudo dpkg -i cloudshell2-fan_20170420-1_armhf.deb
+=== 3. Configure the IR Sensor ===
+Use the automated tool to configure it. ([[https://github.com/mdrjr/cloudshell_ir|Github Project page]])
+<code>wget https://raw.githubusercontent.com/mdrjr/cloudshell_ir/master/install_ir.sh
+chmod +x install_ir.sh
+sudo ./install_ir.sh
+</code>
 CloudShell2 server LCD configuration
   wget https://github.com/john1117/cloudshell-lcd/raw/master/cloudshell-lcd_20170420-4_armhf.deb
   sudo dpkg -i cloudshell-lcd_20170420-4_armhf.deb