Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
en:usb_uart_kit [2016/04/07 12:45] odroid [UART Console Connector] |
en:usb_uart_kit [2016/12/18 11:01] odroid [UART Console Connector] |
||
---|---|---|---|
Line 82: | Line 82: | ||
1.8V LVTTL for ODROID-U3/XU3/XU4/X2/X | 1.8V LVTTL for ODROID-U3/XU3/XU4/X2/X | ||
- | 3.3V LVTTL for ODROID-C1/C1+/C2/W | + | 3.3V LVTTL for ODROID-C1/C1+/C0/C2/W |
- | The VCC pin is not a power source but a reference voltage detect. | + | RxD pin is input and TxD pin is output. |
+ | |||
+ | The VCC pin is not a power source but a reference voltage input. | ||
It is used for detecting the IO voltage like a VIO or a VDDIO. | It is used for detecting the IO voltage like a VIO or a VDDIO. | ||
Support for I/O interface voltages down to 1.8 V is provided via a VIO pin. | Support for I/O interface voltages down to 1.8 V is provided via a VIO pin. | ||
Line 90: | Line 92: | ||
- | Molex 5268-04a(2.5mm pitch) is mounted on the PCB. \\ | + | **Molex 5268-04a(2.5mm pitch) is mounted on the PCB. \\ |
- | Its mate is Molex 50-37-5043 Wire-to-Board Crimp Housing. | + | Its mate is Molex 50-37-5043 Wire-to-Board Crimp Housing.\\ |
+ | 45 degreed corner edge is a mark for pin number 1.** | ||
====== USB UART Schematic ====== | ====== USB UART Schematic ====== |