Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
en:odroidshow [2015/02/12 12:27] john1117 [Tutorials] |
en:odroidshow [2016/05/04 11:27] john1117 [Tutorials] |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== Introduction ====== | ||
+ | {{:en:show_board.jpg?400|}}\\ | ||
+ | The ODROID-SHOW is the Arduino compatible that lets you see what your ODROID or PC is thinking using a small 2.2” TFT LCD. Price is only US$25.\\ | ||
+ | You can show colorful texts and pictures via USB interface with VT100/ANSI style commands without big HDMI monitor.\\ | ||
+ | You can connect this tiny display to your ODROID as well as Mac, Linux PC, Windows PC even an enterprise server.\\ | ||
+ | The form factor is designed for stacking on the ODROID-U3 and it comes with some PCB spacers and a USB cable.\\ | ||
+ | There are I2C, ADC, GPIO pins for further expansion. We will introduce an add-on board with some sensor chips.\\ | ||
+ | You can make it portable device with on-board regulator by adding 3~4 alkaline batteries.\\ | ||
+ | Because of very low power consumption, this is very useful for Wearable projects. | ||
+ | <WRAP center round important 100%> | ||
+ | ** The DTR reset jumper MUST be installed when you upload the firmware.**\\ | ||
+ | ** The DTR reset jumper must NOT be installed in normal usage mode.** | ||
+ | </WRAP> | ||
+ | |||
+ | [[http://www.hardkernel.com/main/products/prdt_info.php?g_code=G141743018597|Where to buy]] | ||
+ | ====== Hardware ====== | ||
+ | * [[SHOW_Hardware|Hardware]] | ||
+ | |||
+ | ====== Firmware ====== | ||
+ | * [[SHOW_Firmware | SHOW main]] | ||
+ | ====== Tutorials ====== | ||
+ | ==== Basic tutorials ==== | ||
+ | * [[SHOW_setting | Setting up the ODROID-SHOW on Ubuntu]] | ||
+ | * [[SHOW_using | How to use ODROID-SHOW with ANSI/VT100 commands]] | ||
+ | * [[SHOW_examples] | ODROID-SHOW examples ]] | ||
+ | * [[http://forum.odroid.com/viewtopic.php?f=53&t=7715|Using Python to interact with ODROID-SHOW]] | ||
+ | |||
+ | ---- | ||
+ | ==== Application-Framework on Host PC ==== | ||
+ | [[https://github.com/thecalicojack/odroid_show_control|{{:en:odroidshow:app.jpg?300|}}]] | ||
+ | * [[ https://github.com/thecalicojack/odroid_show_control ]] | ||
+ | |||
+ | ---- | ||
+ | ====== Accessories ====== | ||
+ | * [[en:weather-board | Weather-Board]] | ||
+ | ====== Portable/Wearable ODROID-SHOW ====== | ||
+ | You can make it portable device with 750mAh Battery.\\ | ||
+ | Because of very low power consumption, this is very useful for Wearable projects. | ||
+ | |||
+ | {{:en:Odroidshow:show2_battery.jpg?500|}} |