Differences

This shows you the differences between two versions of the page.

--- en:odroid-ups2 [2016/03/21 16:01]
ruppi [ODROID-C1/C2]
+++ en:odroid-ups2 [2016/03/21 16:49]
ruppi [ODROID-C1]
@@ Line 96: / Line 96: @@
   - Detailed connection picture between JP1 of UPS2 and the 40pin header(**J2**) of ODROID-C1.
 |　C1|{{:en:ups2:odroid-c1_a_type_ups2-6_1..jpg?300|}}||UPS2|{{:en:ups2:odroid-c1_a_type_ups2-6_2.jpg?300|}}|
+Due to hardware limitations, in order to use the UPS2 on ODROID-C2\\
+  - Extract the blue cable of the 3-pin socket,\\
+  - Connect the 3-pin socket as shown in the figure above the 40 pin Header.\\
+The extracted lines connect the pin #26 of the 40 pin header as shown below.\\
+{{:en:connection_ups2_for_odroidc2.png?400|}}
-===== ODROID-C2 =====
-  - Detailed connection picture between JP1 of UPS2 and the 40pin header(**J2**) of ODROID-C2.
 ====== ODROID safe shutdown in the event of a power outage =====
@@ Line 110: / Line 116: @@
 The AC_OK signal is connected to PIN#11(GPIO #88) in the 40pin header(**J2**) of ODROID-C1/C2.\\
 The BAT_OK signal is connected to PIN#13(GPIO #116).\\
-The POWER_LATCH signal is connected to PIN#15(GPIO #115) on ODROID-C1.\\
+The POWER_LATCH signal is connected to PIN#15(GPIO #115) of ODROID-C1.\\
-The POWER_LATCH signal is connected to PIN#26(GPIO #225) on ODROID-C2.\\
+The POWER_LATCH signal is connected to PIN#26(GPIO #225) of ODROID-C2.\\
 **The BAT_OK pin is high when the battery voltage is higher than 3.7V.\\