Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
en:c2_hardware_1w [2016/11/03 09:09] odroid [Change the Default GPIO pin for 1-Wire interface] |
en:c2_hardware_1w [2016/11/14 15:11] odroid [Dallas 1-Wire Support] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ===== Dallas 1-Wire Support ===== | + | ====== Dallas 1-Wire Support ====== |
* Support for Dallas 1 Wire is included on Kernel 3.14.29-29 and upwards. Make sure you are updated. | * Support for Dallas 1 Wire is included on Kernel 3.14.29-29 and upwards. Make sure you are updated. | ||
Line 59: | Line 59: | ||
Two sensors in parallel. | Two sensors in parallel. | ||
- | ===== Change the Default GPIO pin for 1-Wire interface ===== | + | ====== Change the Default GPIO pin for 1-Wire interface ====== |
Ex) Default GPIO pin change to GPIOX.BIT19 \\ | Ex) Default GPIO pin change to GPIOX.BIT19 \\ | ||
Please refer to below links for details related to gpio mapping in the device-tree.\\ | Please refer to below links for details related to gpio mapping in the device-tree.\\ |