Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
en:c2_hardware [2017/01/14 15:23] odroid [Enable the OTG device function on ODROID-C2] |
en:c2_hardware [2017/06/30 16:55] john1117 [Expansion Connectors] |
||
---|---|---|---|
Line 69: | Line 69: | ||
ODROID-C2 deosn't support the HW SPI. | ODROID-C2 deosn't support the HW SPI. | ||
- | [[http://forum.odroid.com/viewtopic.php?f=137&t=21858#p148325|Printable Pin Template file made by TrippleAAA ]]\\ | + | {{:odroid-c2:c2_j2.jpg?587|}} |
- | {{:en:pinmap.png?100}} | + | |
**J7 - 1x7 pins** | **J7 - 1x7 pins** | ||
Line 77: | Line 76: | ||
^ Pin Number ^ Expansion Net Name ^ Description ^ Driving Capability ^ | ^ Pin Number ^ Expansion Net Name ^ Description ^ Driving Capability ^ | ||
|1|Ground| | | | |1|Ground| | | | ||
- | |2|GPIOAO.BIT6|I2S Data Input, Export GPIO#128| 2mA | | + | |2|GPIOAO.BIT6|SPDIF Output, Export GPIO#128| 2mA | |
|3|P5V0| 5.0V Power| | | |3|P5V0| 5.0V Power| | | ||
|4|GPIOAO.BIT8| I2S MCLK, Export GPIO#130 | 2mA | | |4|GPIOAO.BIT8| I2S MCLK, Export GPIO#130 | 2mA | | ||
Line 84: | Line 83: | ||
|7|GPIOAO.BIT11| I2S Data Output, Export GPIO#133 | 2mA | | |7|GPIOAO.BIT11| I2S Data Output, Export GPIO#133 | 2mA | | ||
+ | |||
+ | {{:odroid-c2:c2_j7.jpg?300|}} | ||
Square soldering pad is Pin #1 as below picture.\\ | Square soldering pad is Pin #1 as below picture.\\ | ||
{{en:c1:c2boardrevision2_i2s.jpg}} \\ | {{en:c1:c2boardrevision2_i2s.jpg}} \\ | ||
+ | |||