Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
en:c2_cvbs [2016/10/13 16:36] joy.cho [Connection] |
en:c2_cvbs [2016/10/14 14:00] joy.cho [CVBS Video Output] |
||
---|---|---|---|
Line 1: | Line 1: | ||
========= CVBS Video Output ======= | ========= CVBS Video Output ======= | ||
- | ( Under construction ) | + | ===== Hardware Example ===== |
- | version.. | + | The below picture is a sample guide. |
- | ===== Connection ===== | + | You can find **cvbs** test point by header J7 near HDMI connector. |
+ | |||
+ | We recommend to use board backside point as the following picture. **Pin 1 of header J7** can be used as Ground point. | ||
{{:en:c2_cvbs1.png?700|}} {{:en:c2_cvbs2.png?700|}} | {{:en:c2_cvbs1.png?700|}} {{:en:c2_cvbs2.png?700|}} | ||
Line 25: | Line 27: | ||
setenv vout "hdmi" | setenv vout "hdmi" | ||
</code> | </code> | ||
+ | |||
+ | ==== Overscan Guide ==== | ||
+ | Please refer to the following article. | ||
+ | |||
+ | http://magazine.odroid.com/wp-content/uploads/ODROID-Magazine-201602.pdf#page=9 | ||
+ | |||
+ | As we tested cvbs mode with our monitors, | ||
+ |