Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
en:c1_tips [2016/01/12 16:20] joy.cho [How to change the value of hdmimode] |
en:c1_tips [2017/11/14 10:48] codewalker [Using FASTBOOT] |
||
---|---|---|---|
Line 47: | Line 47: | ||
=== U-boot === | === U-boot === | ||
If you are able to get into U-boot, this is simply possible with 3 commands below. This will change the resolution value and restart the board. | If you are able to get into U-boot, this is simply possible with 3 commands below. This will change the resolution value and restart the board. | ||
+ | This scheme is only available when booting with 'boot.ini' is not used. | ||
<code> | <code> | ||
setenv hdmimode 1080p | setenv hdmimode 1080p | ||
Line 169: | Line 170: | ||
Next, run **fastboot** command from your desktop. | Next, run **fastboot** command from your desktop. | ||
<code> | <code> | ||
- | $ fastboot flash logo hardkernel-720.bmp | + | $ fastboot flash logo hardkernel-720.bmp.gz |
</code> | </code> |