We're no longer updating This wiki!!

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
en:c2_lirc_gpio_blaster [2016/11/29 16:29]
joy.cho [Building and Testing an IR LED Circuit]
en:c2_lirc_gpio_blaster [2017/06/20 16:09] (current)
joy.cho [Support GPIO based IR Blaster]
Line 2: Line 2:
 <WRAP center round important>​ <WRAP center round important>​
 This functionality is available on Ubuntu. This functionality is available on Ubuntu.
-  * ODROID-C2 : Version should be 3.14.79-94 (Nov 21 2016) or higher. +  * ODROID-C2 : Version should be 3.14.79-94 (Nov 212016) or higher. 
-  * ODROID-C1 : Version should be 3.10.104-175 (Nov 21 2016) or higher.+  * ODROID-C1 : Version should be 3.10.104-175 (Nov 212016) or higher. 
 +  * ODROID-XU3/​4 : Version should be 4.9.33-42 (Jun 20, 2017) (available on kernel 3.10 with 3.10.104-126 (Nov 29, 2016))
 </​WRAP>​ </​WRAP>​
  
Line 49: Line 50:
 |  GND  | Pin #28 - Ground ​ | |  GND  | Pin #28 - Ground ​ |
 |  GPIO  | Pin #26 - GPIO #24   | |  GPIO  | Pin #26 - GPIO #24   |
 +
 +**In case of XU4, voltage level of VDD_IO and GPIO output is 1.8V.\\
 +Supposing R2 is 10 Ohm, the actual forward current is around 40mA and voltage difference between P1 and P2 is around 400mV. \\ **
  
 http://​odroid.com/​dokuwiki/​doku.php?​id=en:​xu4_hardware#​expansion_connectors http://​odroid.com/​dokuwiki/​doku.php?​id=en:​xu4_hardware#​expansion_connectors
-===== Installing ​and Configuring the LIRC and the driver module ​ =====+===== Install LIRC Package ​ ===== 
 +<​code>​ 
 +$ sudo apt-get install lirc 
 +</​code>​ 
 + 
 +Install LIRC package. While installing lirc, you will be asked the device type of IR receiver ​and transmitter.\\ 
 +Since we will set up later by manual, you can select **None**.\\ 
 + 
 + 
 +And for further information,​ please refer to the following wiki page.\\ 
 +http://​odroid.com/​dokuwiki/​doku.php?​id=en:​c2_lirc 
 + 
 +===== Configuring the LIRC and the driver module ​ =====
 === LIRC Configuration === === LIRC Configuration ===
  
en/c2_lirc_gpio_blaster.1480406362.txt.gz · Last modified: 2016/11/29 16:29 by joy.cho
CC Attribution-Share Alike 3.0 Unported
Driven by DokuWiki Recent changes RSS feed Valid CSS Valid XHTML 1.0