Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
en:c2_hardware_1w [2016/11/14 15:11] odroid [Dallas 1-Wire Support] |
en:c2_hardware_1w [2017/05/04 20:22] odroid |
||
---|---|---|---|
Line 4: | Line 4: | ||
* Will cover an example of a temperature sensor well known **DS1820** other 1 wire IC's are supported too. | * Will cover an example of a temperature sensor well known **DS1820** other 1 wire IC's are supported too. | ||
+ | <WRAP left round tip 70%> | ||
+ | You have to check **/etc/modprobe.d/w1_gpio.conf** file to enable the 1-wire driver. | ||
+ | </WRAP> | ||
+ | \\ | ||
+ | \\ | ||
+ | \\ | ||
+ | \\ | ||
+ | \\ | ||
+ | \\ | ||
Default GPIO for 1-Wire is **Pin #7 (GPIOX.BIT21)** | Default GPIO for 1-Wire is **Pin #7 (GPIOX.BIT21)** |