Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:c2_hardware [2017/01/14 15:23] odroid [Enable the OTG device function on ODROID-C2] |
en:c2_hardware [2017/07/04 11:01] (current) john1117 [Expansion Connectors] |
||
|---|---|---|---|
| Line 69: | Line 69: | ||
| ODROID-C2 deosn't support the HW SPI. | ODROID-C2 deosn't support the HW SPI. | ||
| - | [[http://forum.odroid.com/viewtopic.php?f=137&t=21858#p148325|Printable Pin Template file made by TrippleAAA ]]\\ | + | {{:odroid-c2:c2_j2_2.png?600|}} |
| - | {{:en:pinmap.png?100}} | + | |
| **J7 - 1x7 pins** | **J7 - 1x7 pins** | ||
| Line 77: | Line 76: | ||
| ^ Pin Number ^ Expansion Net Name ^ Description ^ Driving Capability ^ | ^ Pin Number ^ Expansion Net Name ^ Description ^ Driving Capability ^ | ||
| |1|Ground| | | | |1|Ground| | | | ||
| - | |2|GPIOAO.BIT6|I2S Data Input, Export GPIO#128| 2mA | | + | |2|GPIOAO.BIT6|SPDIF Output, Export GPIO#128| 2mA | |
| |3|P5V0| 5.0V Power| | | |3|P5V0| 5.0V Power| | | ||
| |4|GPIOAO.BIT8| I2S MCLK, Export GPIO#130 | 2mA | | |4|GPIOAO.BIT8| I2S MCLK, Export GPIO#130 | 2mA | | ||
| Line 84: | Line 83: | ||
| |7|GPIOAO.BIT11| I2S Data Output, Export GPIO#133 | 2mA | | |7|GPIOAO.BIT11| I2S Data Output, Export GPIO#133 | 2mA | | ||
| + | |||
| + | {{:odroid-c2:c2_j7_2.png?600|}} | ||
| Square soldering pad is Pin #1 as below picture.\\ | Square soldering pad is Pin #1 as below picture.\\ | ||
| {{en:c1:c2boardrevision2_i2s.jpg}} \\ | {{en:c1:c2boardrevision2_i2s.jpg}} \\ | ||
| + | |||
