| 1. | 2. | ||
|---|---|---|---|
 | Screw the left and right pieces to the hard disks. (A + B + P) |  | Attach the Cloudshell-2 board to the hard disks.(K) |
| 3. | 4. | ||
 | Screw CloudShell-2 board to left/right pieces. (O) |  | Assemble the FAN and back piece and place the FAN at the back side. Use only 3 screws in this step. (E + G + N) |
| 5. | 6. | ||
 | Insert the FAN cable to the CloudShell-2 board. |  | If you want to use quiet fan mode, connect the current limit PCB between the FAN cable connector and the Cloudshell-2 board. |
| 7. | 8. | ||
 | Assemble the ODROID-XU4 and XU4 holder pieces. (J + M + Q + R) |  | Connect micro B side of USB 3.0 cable to the Cloudshell-2 board. (H + K) |
| 9. | 10. | ||
 | Connect GPIO ribbon cable between ODROID-XU4 and CloudShell-2 board. (F + K) |  | Connect type A side of USB 3.0 cable to ODROID-XU4. |
| 11. | 12. | ||
 | Place the front piece at the front side. (C) |  | Cover the top piece on the top. (D) |
| 13. | 14. | ||
 | Put the locker piece and screw it. (I + N) | ||