odroid-c2:gettingstart:c2_gettingstart_otg_booting [ODROID Wiki]

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

<WRAP round important 60%>
If you want to boot the ODROID-C2 via otg port, please using 5V/2A adapter.\\
OTG booting is unstable in some environment.\\
Most features are described in [[en:c2_hardware#enable_the_otg_device_function_on_odroid-c2|here]]
</WRAP>

This page describes the use of the OTG port.\\

==== OTG Booting ====
The ODROID-C2 can be powered by not only DC jack, but also OTG port.\\
Before using a OTG port, you should check your ODROID-C2 header pin J1.

{{odroid-c2:gettingstart:connect_j1_otg.png?direct|}}

As you can see, when you want to power the ODROID-C2 via the OTG port, you have to plug the J1 jumper.\\
If the J1 jumper is not connected, the OTG port can't be used for the power input.\\

==== OTG port & DC jack ====
{{odroid-c2:gettingstart:wrong_j1.png?direct|}}

But when you connect ODROID-C2 to the DC jack and the OTG port together, and ODROID-C2 be powered via DC jack, you must remove the J1 jumper!\\
Otherwise, your C2 board can be damaged.

{{odroid-c2:gettingstart:j1_disconnected.png?direct|}}

So you should disconnect J1 pins like the above picture.