We're no longer updating This wiki!!

1. 2.
Screw the left and right pieces
to the hard disks. (A + B + P)
Attach the Cloudshell-2 board
to the hard disks.(K)
3. 4.
Screw CloudShell-2 board
to left/right pieces. (O)
Assemble the FAN and back piece and
place the FAN at the back side.
Use only 3 screws in this step. (E + G + N)
5. 6.
Insert the FAN cable
to the CloudShell-2 board.
If you want to use quiet fan mode,
connect the current limit PCB between
the FAN cable connector and
the Cloudshell-2 board.
7. 8.
Assemble the ODROID-XU4 and
XU4 holder pieces. (J + M + Q + R)
Connect micro B side of USB 3.0 cable
to the Cloudshell-2 board. (H + K)
9. 10.
Connect GPIO ribbon cable
between ODROID-XU4 and
CloudShell-2 board. (F + K)
Connect type A side of USB 3.0 cable
to ODROID-XU4.
11. 12.
Place the front piece
at the front side. (C)
Cover the top piece on the top. (D)
13. 14.
Put the locker piece and screw it. (I + N)
en/xu4_cloudshell2/assembling_cs2.txt · Last modified: 2017/04/14 16:10 by odroid
CC Attribution-Share Alike 3.0 Unported
Driven by DokuWiki Recent changes RSS feed Valid CSS Valid XHTML 1.0