Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:xu4_cloudshell2 [2017/05/25 22:56] neal [References] |
en:xu4_cloudshell2 [2017/07/17 11:41] (current) odroid [6. Turn off the fan] |
||
|---|---|---|---|
| Line 46: | Line 46: | ||
| ====== Hardware ====== | ====== Hardware ====== | ||
| - | **Cloudshell-2 Schematic** : {{ :en:acc:cs2:cloudshell2.pdf |}} | + | |
| + | * {{:en:acc:cs2:cloudshell2.pdf | XU4 Cloud Shell Rev0.4 Schematic}} | ||
| + | * [[http://dn.odroid.com/cloudshell2/3MM_170313.DXF|XU4 Cloud Shell 2D drawing 3MM parts (.dxf)]] | ||
| + | * [[http://dn.odroid.com/cloudshell2/5MM_170313.DXF|XU4 Cloud Shell 2D drawing 5MM parts (.dxf)]] | ||
| {{:en:cloudshell2_board.jpg?650|}} | {{:en:cloudshell2_board.jpg?650|}} | ||
| Line 119: | Line 123: | ||
| If you want to disable the LCD script, then you should run following command. | If you want to disable the LCD script, then you should run following command. | ||
| sudo apt-get remove cloudshell-lcd | sudo apt-get remove cloudshell-lcd | ||
| + | |||
| + | ===== 6. Turn the Fan off/on ===== | ||
| + | You can turn the fan off with following command. | ||
| + | sudo i2cset -y 1 0x60 0x05 0x05 | ||
| + | Turn it on again. | ||
| + | sudo i2cset -y 1 0x60 0x05 0x00 | ||
| + | |||
| + | If you want to disable the fan always, remove the cloudshell2-fan package. | ||
| + | sudo apt-get remove cloudshell2-fan | ||
| + | sudo reboot | ||
| ====== Detail installations ====== | ====== Detail installations ====== | ||
| * [[xu4_cloudshell2_raid_setting|How to set the RAID mode]] | * [[xu4_cloudshell2_raid_setting|How to set the RAID mode]] | ||
