Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:usb_uart_kit [2016/04/07 12:45] odroid [UART Console Connector] |
en:usb_uart_kit [2016/12/18 11:01] (current) odroid [UART Console Connector] |
||
|---|---|---|---|
| Line 82: | Line 82: | ||
| 1.8V LVTTL for ODROID-U3/XU3/XU4/X2/X | 1.8V LVTTL for ODROID-U3/XU3/XU4/X2/X | ||
| - | 3.3V LVTTL for ODROID-C1/C1+/C2/W | + | 3.3V LVTTL for ODROID-C1/C1+/C0/C2/W |
| - | The VCC pin is not a power source but a reference voltage detect. | + | RxD pin is input and TxD pin is output. |
| + | |||
| + | The VCC pin is not a power source but a reference voltage input. | ||
| It is used for detecting the IO voltage like a VIO or a VDDIO. | It is used for detecting the IO voltage like a VIO or a VDDIO. | ||
| Support for I/O interface voltages down to 1.8 V is provided via a VIO pin. | Support for I/O interface voltages down to 1.8 V is provided via a VIO pin. | ||
| Line 90: | Line 92: | ||
| - | Molex 5268-04a(2.5mm pitch) is mounted on the PCB. \\ | + | **Molex 5268-04a(2.5mm pitch) is mounted on the PCB. \\ |
| - | Its mate is Molex 50-37-5043 Wire-to-Board Crimp Housing. | + | Its mate is Molex 50-37-5043 Wire-to-Board Crimp Housing.\\ |
| + | 45 degreed corner edge is a mark for pin number 1.** | ||
| ====== USB UART Schematic ====== | ====== USB UART Schematic ====== | ||
