Differences

This shows you the differences between two versions of the page.

--- en:c2_hardware_pwm [2016/02/29 14:27]
ck.kim [Usage]
+++ en:c2_hardware_pwm [2017/01/31 19:10] (current)
odroid [freq0]
@@ Line 8: / Line 8: @@
 ===== Usage =====
-For pin position, numbers and names, please refer to the pinmap [[http://odroid.com/dokuwiki/doku.php?id=en:c1_hardware#expansion_connectors|Expansion Connector]]
+For pin position, numbers and names, please refer to the pinmap [[http://odroid.com/dokuwiki/doku.php?id=en:c2_hardware#expansion_connectors|Expansion Connector]]
 === Option 1: Single PWM ===
 The code below loads the PWM module with a single PWM and the PWM controller module.
@@ Line 20: / Line 20: @@
-=== Option 2: Two PWM ===
+=== Option 2: Two PWMs ===
 //**PWM PINS:**//
@@ Line 32: / Line 32: @@
 </code>
+<WRAP left round important 100%>
+If you are using TWO pwm setup, PWM1 & SPI can not be used simultaneously.\\
+Because GPIOX_7(pin19) has two function spi_mosi & pwm.
+</WRAP>
 ==== Examples of usage ====
 You can control this pwm via simple sysfs entries.
-On **/sys/devices/platform/pwm-ctrl** You'll find the following files:
+On **/sys/devices/platform/pwm-ctrl/** You'll find the following files:
 ==== duty0 ====
@@ Line 59: / Line 63: @@
 enable1, freq1, duty1
 </WRAP>
+==== How to access the PWM port in C language ====
+[[http://forum.odroid.com/viewtopic.php?f=141&t=25563#p177696|Example code by paulcrawford ]]