{{:en:acc:cs2:package_include_2.png?800|}}

^  1.  ^^  2.   ^^
|{{:en:acc:cs2:asm0.jpg?200 |}}|Screw the left and right pieces\\ to the hard disks. (A + B + P)|{{:en:acc:cs2:asm1.jpg?200 |}}|Attach the Cloudshell-2 board\\ to the hard disks.(K)|
^  3.  ^^  4.   ^^
|{{:en:acc:cs2:asm2.jpg?200 |}}|Screw CloudShell-2 board\\ to left/right pieces. (O)|{{:en:acc:cs2:asm3.jpg?200 |}}|Assemble the FAN and back piece and\\ place the FAN at the back side.\\ Use only 3 screws in this step. (E + G + N)|
^  5.  ^^  6.   ^^
|{{:en:acc:cs2:asm4.jpg?200 |}}|Insert the FAN cable\\ to the CloudShell-2 board.|{{:en:acc:cs2:fan_quiet.png?200|}}|__**If you want to use quiet fan mode,\\ connect the current limit PCB between \\ the FAN cable connector and \\ the Cloudshell-2 board.**__|
^  7.  ^^  8.  ^^
|{{:en:acc:cs2:asm5.jpg?200 |}}|Assemble the ODROID-XU4 and\\ XU4 holder pieces. (J + M + Q + R)|{{:en:acc:cs2:asm6.jpg?200 |}}|Connect micro B side of USB 3.0 cable\\ to the Cloudshell-2 board. (H + K)|
^  9.  ^^  10.   ^^
|{{:en:acc:cs2:asm7.jpg?200 |}}|Connect GPIO ribbon cable \\ between ODROID-XU4 and\\ CloudShell-2 board. (F + K)|{{:en:acc:cs2:asm8.jpg?200 |}}|Connect type A side of USB 3.0 cable\\ to ODROID-XU4.|
^  11.  ^^  12.   ^^
|{{:en:acc:cs2:asm9.jpg?200 |}}|Place the front piece\\ at the front side. (C)|{{:en:acc:cs2:asm10.jpg?200 |}}|Cover the top piece on the top. (D)|
^  13.  ^^  14.   ^^
|{{:en:acc:cs2:asm11.jpg?200 |}}|Put the locker piece and screw it. (I + N)|